All-In-One 1KWh ESS
The All-In-One 1kWh ESS combines a 1004.8Wh LiFePO4 battery, inverter and controller in one wall-mountable unit. It provides 500W pure sine wave AC output, 300W maximum PV input and AC charging up to 500W. Four 12V DC ports, USB-C PD, USB-A outputs, smart BMS protection support residential backup projects.
Key Features
- ✓1004.8Wh LiFePO4 energy capacity in a compact all-in-one ESS
- ✓500W pure sine wave AC output through one 230V outlet
- ✓AC charging up to 500W through the C14 inlet socket
- ✓Solar PV charging up to 300W with 11-55V input range
- ✓Four 12V DC ports with 48W total maximum output
- ✓USB-C PD 20W, USB-A QC 20W and USB-A 5V/3A outputs
- ✓Smart BMS with over-voltage, over-current, temperature and short-circuit protection
- ✓Wall-mountable 10.5kg enclosure for small residential backup applications
Technical Specifications
Common FAQs
The unit provides 500W AC output through one 230V outlet, plus 12V DC and USB outputs for compatible devices. It is intended for small residential backup loads within the published output limits. Confirm starting current, continuous power, power factor and required backup duration for each load before ordering.
Begin with the published 1004.8Wh energy figure, then account for inverter efficiency, load profile, battery reserve, temperature and cable or conversion losses. Divide usable watt-hours by the measured load in watts for an initial estimate. Actual runtime depends on the complete system and operating conditions.
Yes. The specification lists AC charging up to 500W through the C14 inlet and solar PV charging up to 300W through an 11-55V input with 10A maximum current. Confirm source compatibility, wiring and charging conditions before installation. The listed charging methods are AC and solar PV.
The unit includes one 230V AC outlet rated at 500W, four 12V DC ports with 48W total maximum output, USB-C PD 20W, USB-A QC 20W and USB-A 5V/3A. Match each device to the correct voltage, current and connector, and verify startup demand before connection.
The enclosure measures 304 × 180 × 245mm, weighs 10.5kg and is wall-mountable. The published operating temperature is 15-55°C. Confirm wall structure, clearances, cable routing, ventilation and service access for the intended installation. Mounting hardware and site suitability should be confirmed with our team before ordering.
A smart BMS provides over-voltage, over-current, over-temperature and short-circuit protection. The battery is specified for 6,000 cycles at 0.5C, 90% depth of discharge and 25°C. Cycle results depend on charging, discharging, temperature, storage and installation conditions.
UN38.3, CE and RoHS documents are available. Every order includes a 3-year limited warranty. Confirm target-market documentation, labeling and import requirements before ordering. Provide the application, quantity, destination and installation conditions so the available document set can be checked for the project.
Provide the target application, required loads, backup duration, AC voltage and frequency, solar PV conditions, installation method, quantity and destination. Include whether wall mounting, USB or DC outputs are required. This information allows the configured system, documentation and commercial details to be confirmed with our team.